RP5-GM51

RadioPRO Radio Replacement Interface for Select General Motors Vehicles

Product Features:

• Compatible with select 2014-2019 vehicles from GMC, Chevrolet, Buick
• Designed to install a new aftermarket car stereo
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, and V.S.S)
• Pre-programmed to retain Steering Wheel Controls
• Retains factory OnStar retention
• Retains all safety and warning chimes
• Retains RSE (rear seat entertainment)
• Retains the factory AUX-IN jack
• Micro-B USB updatable

Compatibility Notes

• Does not retain factory satellite radio
• PAC-UP required to configure vehicle settings
• 2016+ vehicles with RPO codes IOA or IOB must also use the RP5-GM52-HAR. RPO codes can be found on a silver sticker either in the glove box or in the trunk near the spare tire well.
• 2015 + Colorado/Canyon must use Revision 1.1.4 or higher and Vehicle Settings revision 2.0.7 or higher
• 2015 + Tahoe/Suburban/Yukon must use Revision 1.1.3 or higher and Vehicle Settings revision 2.0.6 or higher. You must use Interface Updater 2.0 to update an RP5-GM51.
• Chevrolet Impala: Not compatible in vehicles with the IO3 RPO code. RPO code must be IO5 or IO6. RPO codes can be found on a silver sticker in the trunk near the spare tire well. If the radio looks like the one pictured (found in "Classic" or "Limited" trims), you must use the RP5-GM31.
• 
• Does not retain RSE system
• 2014 Vehicles: Only compatible with 1500 series trucks. 2500 & 3500 series trucks equipped with non-navigation radios must use the RP5-GM31. 2500 & 3500 series trucks equipped with navigation radios must use the RP5-GM32
• Does not retain Bose amplifier. Information on how to bypass the factory amp is included in the instructions
• Does not retain steering wheel control backlighting